TM 9--2815--247--34
0064 00--19
ENGINE CRANKSHAFT REPAIR -- CONTINUED
0064 00
Installation -- Continued
NOTE
To avoid interference with the starter driven gearshaft, it
is necessary to install lower No. 7 tie rod from the right
side of block.
21. Install 14 tie rods (4) through block and apply a small amount of sealant to one threaded portion of each tie rod.
NOTE
Care should be taken so that tie rods extend equally on
both sides of block.
22. Install seven washers (3), 14 slotted nuts (2), and 14 new cotter pins (1).
Figure 2
4
4
4
4
4
4
4
2
1
3
23. Install seven washers (3) and 14 slotted nuts (2) onto tie rods. Do not tighten or install new cotter pins at this
time.
Figure 2
TYPICAL 7 PLACES
2
3
|
|
