TM 9--2815--247--34 0064 00--22 ENGINE CRANKSHAFT REPAIR -- CONTINUED 0064 00 Installation -- Continued 29. Repeat steps 24 through 28 in the following sequence for the remaining six main bearing caps: 3, 5, 2, 6 ,1 and then 7. 30. Secure 28 slotted nuts (6) with new lockwire (5). Figure 2 5 7 6 5 4 3 2 1 6 TYPICAL 7 PLACES 31. Install accessory drive spur gear and oil seal housing support. Refer to WP 0068 00. 32. With the aid of a helper holding slotted nuts (2) on the opposite side of block, torque tighten 14 slotted nuts (2) on tie rods (4) to 53 lb--ft (72 NSm), plus additional torque to align slotted nut with hole in tie rod. 33. Install 14 new cotter pins (1) to secure slotted nuts (2). Figure 2 TYPICAL 7 PLACES 2 1 4 NOTE FOLLOW--ON MAINTENANCE: Install connecting rod assemblies (WP 0070 00) Install cylinder head assemblies (WP 0059 00) Install accessory drive spur gear (WP 0068 00) Install crankshaft oil seal (WP 0067 00) Install oil seal housing assembly (WP 0062 00) Install crankshaft damper (WP 0066 00) Install crankshaft damper and oil filter housing (WP 0079 00) Install oil pressure compartment baffle (WP 0081 00) Install oil pan assembly (WP 0080 00) END OF TASK