TM 9--2815--247--34
0067 00--9
CRANKSHAFT BEARINGS AND ASSOCIATED PARTS REPLACEMENT --
CONTINUED
0067 00
Inspection -- Continued
17. Place dial indicator (22) on each of four studs (14) and measure stud stretch.
18. With dial indicator (22) still on stud (14), apply sufficient torque to each slotted nut (16) to align slot with drilled
hole in stud (14) and to obtain a stud stretch of 0.019 to 0.022 inches (0.4826 -- 0.5588 mm). Do not exceed
0.024 inches (0.6096 mm) stud stretch.
19. Repeat steps 17 and 18 for remaining three studs (14) and slotted nuts (16) on main bearing cap No. 4.
20. Repeat steps 15 through 19, for remaining six main bearing caps, alternating left to right in the following se-
quence: 3, 5, 2, 6, 1, and 7.
Figure 2
22
16
14
7
6
5
4
3
2
1
|
|
