TM 9--2815--247--34 0079 00--1 CRANKSHAFT DAMPER AND OIL FILTER HOUSING ASSEMBLY REPAIR 0079 00 THIS WORK PACKAGE COVERS: Removal, Disassembly, Cleaning, Inspection, Repair, Assembly, Installation INITIAL SETUP: Tools and Special Tools General mechanic’s tool kit (item 19, WP 0103 00) Torque wrench (item 50, WP 0103 00) Four leg sling (item 66, WP 0103 00) Torque wrench (item 51, WP 0103 00) Materials/Parts Pipe plugs (5) (item 108, WP 0102 00) Pipe plugs (2) (item 99, WP 0102 00) Pipe plugs (3) (item 105, WP 0102 00) Pipe plug (item 101, WP 0102 00) Pipe plug (item 107, WP 0102 00) Gasket (item 14, WP 0102 00) Self--locking nuts (4) (item 47, WP 0102 00) Preformed packings (2) (item 66, WP 0102 00) Gasket (item 33, WP 0102 00) Preformed packings (3) (item 69, WP 0102 00) Preformed packing (item 65, WP 0102 00) Self--locking nuts (2) (item 41, WP 0102 00) Lubricant (item 12, WP 0100 00) Sealant (item 21, WP 0100 00) Equipment Conditions Wiring harness 3W202 removed (TM 9--2350--292--20) Engine on maintenance stand (WP 0056 00) Fans, covers, and top deck removed (TM 9--2350--292--20) Pump drive adapter assembly removed (WP 0078 00) Throttle control solenoid assembly and associated parts removed (WP 0048 00) Equipment Conditions Fuel/water separator bracket assembly removed (WP 0090 00) Heater fuel filter mounting bracket removed (WP 0092 00) Manifold heater pump, fuel back flow valve, brackets and lines removed (TM 9--2350--292--20) Manifold heater solenoids and lines removed (TM 9--2350--292--20) Fuel/water separator drain cock and lines removed (TM 9--2350--292--20) Engine installation guides removed (WP 0058 00) Power take--off housing and associated parts removed (WP 0035 00) Engine and transmission oil coolers and lines removed (TM 9--2350--292--20) Oil cooler frames and shrouds removed (TM 9--2350--292--20) Breather tube removed (TM 9--2350--292--20) Oil lines to turbo and metering pump removed (TM 9--2350--292--20) References TM 9--2350--292--20 Personnel Required Three Removal 1.   Remove 12 screws (1) and 12 flat washers (2) from damper and oil filter housing (3). Figure 14 1 2 3