ARMY TM 92815-252-24 AIR FORCE TO 38G1-92-2 3-1 6.2.   Removal. Warning Fuel Is flammable.  Keep fuel away from heat and open name.  Failure to observe this warning could result in severe  personal injury or death NOTE Catch fuel in suitable container. a. Disconnect end Hem fuel supply line from fuel filter (15, FIGURE 3-7). b. If damaged, (or if replacing filter assembly), remove f sting (12) from filter (15). c. Remove swivel union plug (9) securing fuel line (11) to fuel filter (15); remove fuel line (11) and two seals (10). Discard seals (10). d. Remove  two  capscrews  (13)  and  lockwashers  (14)  securing  filter  (15)  to  mounting  bracket  (18);  remove  filter. Discard lockwashers (14). e. If  damaged,  remove  capscrew  (16)  and  lockwasher  (17)  securing  bracket  (18)  to  flywheel  housing.    Discard lockwasher (17). f. Cap all openings. 3-1 6.3. Installation. a. Remove all caps installed during removal. b. If  removed,  position  bracket  (18,  FIGURE  3-7)  on  flywheel  housing  and  secure  with  capscrew  (16)  and  new Iockwasher (17).  Tighten capscrew to 58 fl-lbs (78.6 Nm). c. Position fuel filter (15) on bracket (18) and secure with two capscrews (13) and new lockwashers (14). d. Connect fuel supply line (11) to fuel filter (15) using two new seals (10) and swivel union plug (9). e. If removed or replaced, install fitting (12) in filter (15) f. If required, connect end item fuel supply line to fuel filter (15). 3-17. FUEL INJECTOR. 3-17.1. Removal. Warning Fuel is flammable.  Keep fuel away from heat and open flame.  Failure to observe this warning could result in severe personal injury or death. CAUTION Do not apply excessive force to Injection fuel pipes.   Failure to observe this caution could result in damage to fuel pipes. NOTE Catch fuel in suitable container a. Disconnect and remove fuel injector pipe 3-3. or 4, FIGURE 3-13), refer to paragraph 3-18.1 3-30