ARMY TM 9-2815-253-24
AIR FORCE TO 38G1-93-2
MARINE CORPS TM 2815-24/3
g.
Ensure identification marks on the cap and rod are identical and on the camshaft side of the engine and replace
cap.
h.
Install two bolts (1) and tighten them to 222 in-lbs (25 Nm).
i.
If removed, attach oil pressure relief valve and oil strainer to oil pump.
j.
Install cylinder head. Refer to paragraph 3-27.6.
k.
Install crankcase door. Refer to paragraph 3-20.2.4.
3-31. FLYWHEEL HOUSING.
3-31.1. Removal.
a.
Remove starter. Refer to paragraph 3-24.1.
b.
Remove flywheel. Refer to end item maintenance manual.
c.
Scribe a mark on flywheel housing (1, FIGURE 3-38) and crankcase.
d.
Support weight of flywheel housing (1) and remove four capscrews (2) securing flywheel housing; remove
housing.
3-31.2. Installation.
a.
Position flywheel housing (1, FIGURE 3-38) on crankcase aligning scribe marks made during removal and
secure with four capscrews (2). Tighten capscrews to 58 ft-lbs (78.6 Nm).
b.
Install flywheel. Refer to end item maintenance manual.
c.
Install starter. Refer to paragraph 3-24.6.
FIGURE 3-38. Flywheel Housing
3-65
|
|
