ARMY TM 9-2815-254-24
AIR FORCE TO 36G1-94-2
3-7.2. Inspection.
a.
Inspect pump rotation for abnormal noise, binding, and other abnormal conditions.
b.
Inspect pump housing for cracks, corrosion, or any other damage.
3-7.3.
Replacement. Replace pump assembly if inspection reveals any abnormal condition, such as bearing failure, ex-
cessive end play, or abnormal rotation.
3-7.4. Installation.
Ensure longer bolts (5, FIGURE 3-2) are installed in the location noted
during removal. Failure to observe this caution will result in pump not
being secured properly.
a.
Apply sealant and position new gasket (9). water pump (7) and alternator bracket (8) on engine block and
secure with six screws (5 and 8). Tighten screws to 30 ft-lbs (40.6 Nm)
b.
Position fan pulley (4) spacer (3) and fan (2) on water pump (7) hub and secure with four screws (1). Tighten
screw to 72 in-lbs (8.0 Nm).
c.
Install fan drive belt, refer to end item maintenance manual.
3-19
|
|
