ARMY TM 9-2815-256-24 AIR FORCE TO 38G1-96-2 MARINE CORPS TM 2815-24/5 CAUTION Do not gouge flange of crankshaft with chisel.  Nicks or burrs should be removed with a medium grit stone or polishing cloth (180 grit or finer). d. Carefully cut wear sleeve off crankshaft flange using a small cold chisel. WARNING Cleaning  solvent  is  flammable  and  toxic  to  eyes,  skin,  and  respiratory  tract.    Skin/eye  protection required.  Avoid repeated/prolonged contact.  Good general ventilation is normally adequate. NOTE The unitized design will not allow the seal to be separated from the wear sleeve without destroying the sleeve. e. Clean OD of crankshaft flange with cleaning solvent P-D-680 to remove sealant from flange. f. Look for nicks or burrs on wear ring surface and bore in flywheel housing.  If necessary, use polishing cloth. g. Finish cleaning by wiping flange with a clean rag. 3-36.2.  Installation. WARNING Cleaning  solvent  is  flammable  and  toxic  to  eyes,  skin,  and  respiratory  tract.    Skin/eye  protection required.  Avoid repeated/prolonged contact.  Good general ventilation is normally adequate. a. For proper adhesion and sealing, clean OD of crankshaft flange and ID of wear ring with cleaning solvent just prior to application of sealant.  Make sure that OD of crankshaft flange and ID of seal housing bore are free from nicks or burrs. b. Apply a light coating of sealing compound (MIL-R-46082) retaining sealant completely around the leading edge of crankshaft flange.  Wipe away any sealant that may have gotten on seal housing bore. c. Install pilot from tool set (JT30040) on end of crankshaft using two capscrews.  Tighten both capscrews securely. Make sure tool contacts face of crankshaft. d. Carefully start oil seal/wear sleeve over pilot and crankshaft flange with open side of seal toward engine. e. Attach driver and thrust washer to guide plate with capscrew.  Tighten the capscrew until driver bottoms on pilot. f. Remove capscrew thrust washer, driver, two capscrews, and guide plate. g. Install flywheel, refer to paragraph 3-35.3. 3-37.  FLYWHEEL HOUSING. 3-37.1.  Removal. 3-162