ARMY TM 9-2815-256-24
AIR FORCE TO 38G1-96-2
MARINE CORPS TM 2815-24/5
FIGURE 3-48. Installing Oil Filter Nipple
(2)
Using a tubular driver, push oil filter nipple into cylinder block until it is flush with cylinder block, refer to
FIGURE 3-48.
Figure 3-49. Driving Oil Filter Nipple
b.
Position new preformed packing (11, FIGURE 3-46) and oil cooler on engine block and secure with nipple (9).
Tighten nipple to 27 ft-lbs (37 Nm).
c.
Install two hoses (5 and 6) and two clamps (4) on oil cooler. Do not tighten clamps.
d.
Install two hoses (14) and two clamps (13) on water pump. Tighten clamps.
e.
Connect tube (7) to hoses (6 and 14) using two clamps (3 and 13).
f.
Connect tube (8) to hoses (5 and 14) using two clamps (3 and 13). Tighten all clamps.
g.
Secure strap (19) to engine using existing screw (18).
h.
Secure tubes (7 and 8) to strap (19) using screw (15), flatwasher (16), and clamp (17).
i.
install plug (2) in oil cooler.
Change 3
3-64
|
|
