ARMY TM 9-2815-257-24 AIR FORCE TO 38G1-128-2 MARINE CORPS TM 10155A/2815-24/3 5-16 5-9.  CAMSHAFT ASSEMBLY MAINTENANCE This task covers removal, cleaning, inspection, and installation. INITIAL SETUP Tools: Equipment Condition: Tool Kit, Master Mechanic (Item 3, App. B, Sect. III)     Engine oil drained (Para. 3-5)        Fuel injection pump removed (Para. 4-12) Parts/Materials: Oil, Lubricating (Item 1-5, App. E) Solvent, Dry Cleaning (Item 7, App. E) Rag, Cleaning (Item 8, App. E) Grease, Automotive (Item 9, App. E) A.    REMOVAL. CAUTION When removing crankcase cover, be careful not to damage oil seal. 1. Release crankcase cover (1, Figure 5-9) from cylinder block by removing fifteen screws (2).  Carefully pry crankcase cover from engine crankcase. 2. Remove cover gasket (3).  Discard if damaged or deformed. NOTE Exhaust and intake tappets (6, 7) may fall down when pulling out camshaft assembly.  Keep tappets separate to avoid confusion. 3. Carefully  remove  assembled  camshaft  components  from  cylinder  block.    Remove  exhaust  and  intake tappets (6, 7) and push rods (8, 9). 4. Remove bearing (4) from crankcase cover (1) only if replacement is required.