ARMY TM 9-2815-259-24
AIR FORCE TO 38G1-125-2
MARINE CORPS 09249A/09246A-24
5-28
(7)
Position seal protection tube (included in seal and bearing kit) over drive shaft (Figure 5-32).
Lubricate seal protection tube and drive shaft with clean calibrating fluid.
FIGURE 5-32. SEAL PROTECTION TUBE
(8)
Insert seal protection tool and drive shaft (1, Figure 32) into fuel injection pump housing from
flange end of fuel injection pump housing. Position shoulder of drive shaft flush with drive shaft
bearing (1, Figure 5-31). Hold shoulder of drive shaft flush with face of drive shaft bearing and
remove seal protection tube from inside of fuel injection pump housing.
(9)
Install thrust bearing (1, Figure 5-33) using snap ring pliers (20043). Install thrust washer (2).
FIGURE 5-33. THRUST BEARING AND THRUST WASHER
|
|
