ARMY TM 9-2815-260-24 AIR FORCE TO 38G1-126-2 MARINE CORPS TM 09244A/09245A-24 5-10 (9) Remove adjusting cap assembly (13, Figure 5-1) by twisting and pulling.  Remove O-ring seal (14) and spring pin (15).  Discard O-ring seal. (10) Remove control rod guide (16) and seal washer (17).  Discard seal washer. (11) Disengage governor spring (18) from governor arm (55), refer to Figure 5-4.  Depress metering valve arm (43) and remove control rod assembly (19) and governor spring. FIGURE 5-4.  CONTROL ROD ASSEMBLY AND GOVERNOR SPRING REMOVAL. (12) Remove screw (20), locking plate (21), and O-ring seal (22).  Discard O-ring seal. (13) Loosen but do not remove transfer pump end cap (72) using wrench. (14) Remove head locking screws (23). (15) Invert fuel injection pump housing (1) in vise and remove head locating screw (24) and O-ring seal (25).  Discard O-ring seal. (16) Remove cam advance pin hole plug (26) and O-ring seal (27). (17) Loosen locknut (32).  Remove spring side piston hole plug (28) using wrench. (18) Remove O-ring seal (29), spring (30), spring seat (31), locknut (32), trimmer screw (33), and O- ring seal (34).  Discard O-ring seals. (19) Remove cam advance pin (35) using needle nose pliers, refer to Figure 5-5. (20) Remove power side piston hole plug (36), O-ring seal (37), and advance piston (38).