Connecting Load Cables.

Custom Search

Back
Figure 2-5. Typical Ground Rod Installation.

Up
TM-9-6115-666-13-P AN/MJQ-1612 60kW 50/60 Hz Power Plant Diesel Engine Driven 5 Ton Trailer Mounted Manual

Next
Auxiliary Fuel Source

ARMY TM 9-6115-666-13&P

AIR FORCE TO 35C2-3-505-1

2.3.4. Connecting Load Cables.

WARNING

Never attempt to connect or disconnect load cables while the generator is running. Failure

to observe this warning could result in severe personal injury or death by electrocution.

NOTE

Before connecting the load, determine voltage and frequency requirements of the system or

device that is being supplied with power. Refer to TM 9-61-15-645-10 and verify that

voltage reconnection board is in proper position for voltage requirements and the frequency

select switch is in the proper position. If board requires repositioning notify next higher level

of maintenance.

2.3.4.1. Power Plant. Load can be connected to the switch box using any combination of connectors, J1

through J4, figure 2-6. The paralleling cable is already connected between the generators.

a. Remove load cables from the cable storage box located on trailer.

b. Connect the plug end of cable (1) to the desired connector of the switch box.

Figure 2-6. Connecting Load Cables.

2-31