| Tweet |
Custom Search
|
|
|
||
 HYDRAMECHANICAL PROTECTIVE SYSTEM
SPECIFICATIONS
AIR INTAKE SHUTOFF
(2W7163)
(1)
Hydraulic shutoff cylinder. Make an alignment of
Free length after test ...............54.6 mm (2.15 in.)
cylinder port and vent hole (9) in a vertical
Outside diameter.....................9.04 mm (.356 in.)
downward position at assembly.
(5)
Torque for carrier (put 2P2506 Thread Lubricant
(2)
Torque for nut that holds cylinder (1) to the
on the
flange...............................457 Nm (335 lb. ft.)
threads) ......................... 7010 Nm (507 lb. ft.)
(3)
Diameter of cylinder
(6)
Bore in spring
rod ........................7.9200.013 (.3118.0005 in.)
bushing................19.300.25 mm (.760.010 in.)
Bore in bushing after
Diameter of
assembly ...... 7.9960.044 mm (.3148.0017 in.)
shaft ....................18.970.02 mm (.747.001 in.)
Bore in housing for
(7)
Diameter of
bushing ......... 9.5250.013 mm (.3750.0005 in.)
shaft ....................18.970.02 mm (.747.001 in.)
Install bushing with split along centerline (8)
Bore in two shaft bushings (after
assembly)....19.0500.044 mm (.7500.0017 in.)
toward front or rear.
(4)
2V244 Spring for shutoff actuator pin:
Bore in housing for
bushings......22.2050.013 mm (.8742.0005 in.)
Length under test force .......... 29.2 mm (1.15 in.)
Test force ....................... 8.90.7 N (2.00.16 lb.)
207
|
||
|
||
