| Tweet |
Custom Search
|
|
|
||
 3500 ENGINES
DISASSEMBLY AND ASSEMBLY
CRANKSHAFT REAR SEAL AND WEAR SLEEVE
3.
Install tool (B) over the studs of tooling (A).
Install nuts (C) and tighten the nuts evenly
until the seal is against the bottom of the
adapter bore.
4.
Remove nuts (C), tool (B) and tooling (A)
from the adapter.
NOTE: Do not put engine oil on the lip of the seal during
installation. Lubrication of the seal at installation can be
a wrong indication for linkage at a later time.
5.
Put clean engine oil on the O-ring seal and,
install the seal on the adapter.
6.
Install tooling (D) on the end of the
crankshaft.
7.
Install guide bolts (E) in the drive housing.
Put adapter (3) in position on guide bolts
(E) and over tooling (D). Make sure the
wear sleeve makes contact with the end of
the crankshaft.
8.
Install tool (B) over the small outside
diameter. of tool (F) until tool (B) is against
the shoulder on tool (F).
9.
Install tooling (B) and (F) as a unit on the
guide bolts and over locator.a8'" "A
10. Put clean engine oil on the face of nut (G)
and install nut (G) on the locator. Tighten
nut (G) until the wear sleeve and adapter
are in position.
11. Remove the tooling from the engine.
12. Install bolts (4) to hold adapter (3) in
position.
end by:
a) install flywheel
357
|
||
|
||
