| Tweet |
Custom Search
|
|
|
||
 3500 ENGINES
DISASSEMBLY AND ASSEMBLY
FRONT DRIVE HOUSING
REMOVE FRONT DRIVE HOUSING
1151-
11zit
Tools Needed
A
B
C
6V2156
Link Bracket
2
1P74
Slide Hammer and Puller
1
8B7557
Threaded Adapter
1
1P520
Drive Group
1
start by:
a) remove oil filter housing
b) remove crankcase breather
c) remove front crankshaft seal and wear sleeve
d) remove accessory drive (front)
e) remove governor drive.
NOTE: Make sure there is a new front crankshaft seal
and wear sleeve before the front drive housing is
removed. Anytime the front seal is removed from the
wear sleeve, a new seal and sleeve must be installed.
1.
Remove oil tube (I) from the engine.
2.
Fasten a hoist to support (2) with tooling (A)
and remove support (2) from the drive
housing. The weight of the support is 102
kg (225 lb.).
3.
Remove elbow (3) and tube (4) as a unit
from the engine.
4.
Remove the bolts and use tooling (B) to
remove shaft (6) and idler gear (5) from the
drive housing.
5. If necessary, use tooling (C) to remove the
bearing from idler gear (5).
358
|
||
|
||
