TM 5-2815-241-34&P
ROCKER ARM COVER INSTALLATION
INITIAL SETUP
Tools
Materials/Parts
Screwdriver, flat-tip, 1/4-inch
Socket, 9/16-inch, 3/8-inch drive
Wrench, torque, 0 to 50 ft lb
(0 to 70 Nm), 3/8-inch drive
Gasket
Lockwasher (five required)
Equipment Condition
Engine compression brake housing installed
(page 2-116).
ACTION
LOCATION
ITEM
REMARKS
3.
NOTE
Steps given are typical for all three rocker arm covers.
Only front rocker arm cover contains oil filler cap and crankcase breather.
1. Engine compression
brake housing (1)
2.
Rocker arm cover (3)
New gasket (2) and
rocker arm cover (3)
Five flat washers
(4) five new lock-
washers (5) and
five screws (6)
Crankcase breather
hose (7) and
clamp (8)
Put on.
Using 3/8-inch drive 9/16-inch socket and
0 to 50 ft lb (0 to 70 Nm) torque wrench,
screw in and tighten to 12 to 17 ft lb (16.8 to
23.8 Nm).
a. Put on.
b. Using 1/4-inch flat-tip screwdriver,
tighten clamp.
TASK ENDS HERE
2-118
T A 2 4 2 4 1 0
|
|