TM   5-2815-241-34&P INTAKE   MANIFOLD   INSTALLATION INITIAL   SETUP Tools Materials/Parts Extension,   6-inch,   1/2-inch   drive Socket,   9/16-inch,   1/2-inch   drive Wrench,  open-end,  l-inch  (two required) Wrench,  torque,  0  to  50  ft  lb (0  to  70  N•m),  1/2-inch  drive Gasket   (three   required) Lockwasher   (seven   required) Equipment   Condition Cylinder  heads  installed  (page  2-68). ACTION LOCATION ITEM REMARKS 2. 3. 1.  Cylinder  head  (1) Three   new   gaskets (2)  three  screws (3),  three  new lockwashers   (4), and three flat washers  (5) Put  one  screw,  lockwasher,  and  flat  washer through  gasket  and  into  hole  at  bottom  of each intake port. Intake  manifold  (6) Put  onto  screws  (3). Four  screws  (7), four  new  lockwashers (8),  and  four  flat washers   (9) Screw  in. Do  not  put  screws  in  holes  marked  A. Seven   screws (3 and 7) Using  1/2-inch  drive  9/16-inch  socket,  6- inch  extension  and  0  to  50  ft  lb  (0  to  70  N•m) torque wrench, tighten to 20 to 25 ft lb (28 to 35 N•m). 5. Intake manifold (6) Air  compressor  hose nuts  (10) Using  two  l-inch  open-end  wrenches,  put on  and  tighten. TASK ENDS HERE T A     2 4 2 4 1 1 2-119