*C2
PAR 1 4 3
R I G H T O U T P U T R E B U I L D
C H A P 5, SEC X V I
Figure 159. Removing (or installing) output clutch
assembly
i . R e m o v e s t e e r c l u t c h p l a t e s a n d d i s ks
(fig. 159).
j . R e m o v e s p a c e r ( f i g . 1 5 9 ).
k . U s i n g s l i n g 7 0 8 3 7 7 8 a n d t h r e e 7 / 1 6 -
14 bolts, remove steer clutch anchor (fig. 160).
l . Remove steer clutch piston (fig. 160).
N o t e. Refer to pars. 172 through 176
for rebuild of the steer clutch piston
a s s e m b l y.
m . U s i n g 5 / 8 - i n c h w r e n c h , r e m o v e 19
b o l t s a n d l o c k w a s h e r s t h a t r e t a i n t h e e nd
cover hub (fig. 161).
n . Remove the hub and gasket from the
end cover (fig. 161).
o . Remove two preformed packings from
the hub (fig. 161).
p . R e m o v e r e t a i n i n g r i n g 7 1 ( f i g . 3 8 1,
fold-out 10) that retains bearing 72 in hub 73.
q . Remove bearing 72 from hub 73.
Figure 160. Removing steer clutch anchor
Figure 161. Removing end cover hub
r . D o n o t r e m o v e t h e o i l s e a l f r o m t he
h u b , u n l e s s r e p l a c e m e n t i s n e c e s s a r y ( f i g .
161). If necessary, drive the oil seal out to-
ward the outside of the hub.
s . U s i n g a 9 / 1 6 - i n c h w r e n c h , r e m o v e
eight self-locking bolts 62 (fig. 381, fold-out
10) that retain sleeve 61. Remove sleeve 61,
gasket 60 and preformed packing 59.
t. Remove the bearing 70 from sleeve 61.
u . T h e v a r i o u s p l u g s m a y b e r e m o v ed
from the end cover to aid in cleaning and in-
spection of oil passages (fig. 161).
1 2 3
|
|
