ARMY TM 9-2805-256-14
AIR FORCE TO 38G2-102-2
NAVY NAVFAC P-8-611-14E
C A U T I O N
Equipment operation is allowable with minor leakage (Class 1 or II) of any fluid except
fuel. Of course, consideration must be given to the fluid capacity in the item being
checked/inspected. When in doubt, notify your supervisor.
When operating with Class I or II leaks, continue to check fluid level more often than
required in the PMCS. Parts without fluid will stop working and/or cause equipment
d a m a g e .
Class Ill leaks should be reported to your supervisor or unit maintenance.
f. Painting. Touch-up engine as needed. Refer to TM 43-0139 for specific painting procedures.
Table 2-1. Operator Preventive Maintenance Checks and Services (PMCS).
B - B e f o r e
D - During
A - After
Interval
Item
Item to be Inspected
Equipment is Not
No .
B
D
A
Procedure
Ready/Available If
1
l
E N G I N E
a. Visually inspect engine for signs of
damage or missing parts.
l
l
b. Inspect engine for evidence of fuel or oil
Class III oil leak, or Class I fuel leak is
leaks.
detected.
l
c. Check fuel filter for evidence of contami-
Fuel filter contains contaminated fuel.
nated fuel. Notify unit maintenance if
fuel is contaminated.
l
l
d. Perform lubrication on engine. Refer to
LO 9-2805-256-12 for lubrication
instructions.
l
e. Listen to engine for unusual sounds,
rough running, or excessive exhaust
smoke .
2
l
l
l
AIR CLEANER SERVICE INDICATOR
Check indicator, and notify unit maintenance
Indicator is in the red area.
when indicator is in the red area.
3
l
STARTER ROPE ASSEMBLY
Inspect starter rope for cuts or signs of
Starter rope assembly is worn or
fraying.
d a m a g e d .
2 - 6
|
|
