|
|
|
|
|
TM 9-2815-202-34
c. Installation
(1) Coat upper flange of oil pan (6) with gasket cement.
(2) Install cork gasket (7) by alining holes in gasket with holes in oil pan (6).
(3) Position oil pan and gasket on cylinder block.
(4) Install two bolts (4) in right and left center holes of oil pan (6).
(5) Install two bolts (4) and two flat washers (5) in rear corners of oil pan.
(6) Install twenty-four bolts (4) in oil pan and tighten finger tight.
(7) Install two bolts (1) and two Iockwashers (2) to flywheel housing (3).
(8) Torque twenty-eight oil pan bolts (4) to 10-20 Ib-ft (14-27 N-m) starting with center bolts and
working alternately towards each end.
(9) Torque two bolts (1) to 30-35 Ib-ft (41-47 N-m).
END OF TASK
C h a n g e 1 4-67
|
|
|
|
|
Privacy Statement -
Copyright Information. -
Contact Us
