TM9-2815-202-34 NOTE Record  quantity  and  thickness  of  shims  (26)  for  reinstallation. (13) Remove sleeve (25), shims (26), and piston (27) from housing (24). (14) Remove seal ring (28) from piston (27). Discard seal ring. (15) Remove high speed spring retainer (29) and plunger (30) assembly from governor housing (3). (16) Remove low speed spring cap (31), low speed spring (32) spring seat (33), and adjusting pin (34) from plunger (30). (17) Using a socket head wrench, hold screw (35) and loosen nut (36). WARNING (18) (19) (20) (21) High  speed  spring  is  under  pressure  and  personal  injury  could  occur  if downward  pressure  is  not  applied  to  retainer. (22) (23) (24) (25) While  applying  pressure  to  high  speed  spring  (37),  remove  screw  (35) from  plunger  (30). Remove high speed spring (37) and seat (38) from plunger (30). Remove  plug  (39)  and  gasket  (40)  from  governor  housing  (3).  Discard  gasket. Bend tang of key washer (41) away from retainer bolt (42). While holding weight carrier assembly  (43),  remove  retainer  bolt (42), flat washer (44), and key washer (41).  Discard  key  washer. Thread a 5/16-24 x 3 inch bolt (45) into hole for retainer bolt (42). Remove  governor  housing  (3)  from vise and place on a flat surface with bolt  (45)  facing  up.  Tap  weight  carrier assembly (43) out of bearing (46) with a soft headed hammer. Slide riser bearing  (47) and riser (48) off  weight  carrier  assembly  (43). NOTE Inspect  weight  carrier  bearing  in governor housing to determine need  for  removal. (26) If necessary, remove weight carrier bearing (46) from governor housing (3). Use a small brass rod and hammer to tap bearing from inside housing. 4-251