TM 9-2815-202-34
4-42. GOVERNOR REPAIR (Cont)
(27) Matchmark two high speed and two low speed weights (49 and 50) to weight carrier (51).
(28)
(29)
(30)
(31)
(32)
(33)
(34)
(35)
Remove four retaining rings (52).
Press two pins (53) from weight carrier (51) and remove four washers (54), two high speed
weights (49), and two low speed weights (50).
Using bearing remover tool (55), sleeve (56), and arbor press, remove needle bearing (57)
from one high speed weight (49). Repeat procedure for other high speed weight.
Using an arbor press, remove carrier shaft (58) from weight carrier (51) by placing spline end
into a sleeve (59) having a one inch hole.
Remove retaining clip (60) and flat washer (61 ) from differential lever pin (62) and remove
operating lever connecting link (63).
Remove retaining clip (64) and flat washer (65) from operating lever pin (66). Remove
differential lever (67) from operating lever (68).
If damaged, remove pin (62) from differential lever (67).
For model 7083-7395 only, remove two springs (69) and retainer clips (70). Separate
governor links (71 and 72) and remove pin (73).
4-252
|
|
