(36)
(37)
(38)
(39)
TM 9-2815-202-34
Loosen locknut (74) and remove buffer screw assembly (75).
Remove screw and washer assembly (76) and locking clip (77) securing operating lever
shaft (78) to governor housing (3).
Remove operating lever shaft (78), control link operating lever (79), and two washers (80).
If bearings are damaged, support control link operating lever (79) on sleeve and rest sleeve
on bed of arbor press. Place bearing remover (55) on top of bearing (81) and press two
bearings (81 ) out of operating lever (79).
(40)
(41)
(42)
(43)
(44)
Remove expansion plug (82) from
bottom of governor housing (3).
Discard expansion plug.
Remove operating shaft upper
bearing retainer screw and washer
assembly (83) and flat washer (84)
securing bearing in governor housing
(3).
Place governor housing (3) in press,
bottom side up.
Press operating shaft (85) out of lower
bearing (86) located in governor
housing (3).
Place a 9/16 inch open end wrench
(87) under operating fork (88) and
press fork off operating shaft (85).
4-253
|
|
