TM 9-2815-202-34
4-42. GOVERNOR REPAIR (Cont)
(13)
(14)
(15)
(16)
(17)
Apply a thin coat of sealant to edge of
expansion plug (82).
Using a ballpeen hammer, tap
expansion plug (82), convex side up,
into governor housing (3).
If removed, lubricate outside of two
control link operating lever bearings
(81) with engine oil and lubricate
inside of bearings with grease. Using
bearing installing tool (55), press one
bearing (81), numbered side up, into
control link operating lever (79) until
flush with top of lever. Reverse
operating lever and install second
bearing in same manner.
Insert control link operating lever (79) and two washers (80) between two bosses inside
governor housing (3).
Install operating lever shaft (78) with grooved end up.
4-256
|
|
