|
|
|
|
|
TM9-2815-202-34
(9)
Restrain cam follower body and roller during removal from holder assembly
(92). Follower pin is seated on top of spring loaded plunger in holder
assembly and a sudden release could eject cam follower and cause injury to
personnel.
2.
3.
4.
5.
6.
7.
Remove any burrs on cam follower surfaces at pin holes prior to installing roller and pin
to prevent scoring of roller bushing and pin.
Drive pin (91) from roller (90) with a drift.
Position follower body in groove of holding assembly with small plunger extending
through roller pin hole in one leg of follower body.
Coat pin and roller with engine oil.
Position roller (90) in cam follower body (93). Plunger will extend into roller bushing and
assure accurate alinement of bushing with roller pin holes in follower body.
Start pin (91) squarely into follower body (93) and drive into position until pin is centered
in legs of follower.
Check side clearance between roller (90) and follower body (93). Clearance must be
between 0.011 and 0.023 inch.
. . .
Rocker arms and shafts
Inspect rocker arm shafts and bushings for wear. Maximum shaft to bushing clearance is 0.004
inch.
C h a n g e 1 5-51
|
|
|
|
|
Privacy Statement -
Copyright Information. -
Contact Us
