TM  9-2815-202-34 5-41.  GOVERNOR  REPAIR (7) (8) (9) (10) (11) (12) (13) (14) (15) 5-70 Insert end of governor (Cont) operating  shaft (78), bearing (83), spacer (82),and operating lever (61) through upper bearing bore in governor housing (3) with operating fork (81) facing rear of governor housing. Place  governor  housing  (3)  in  press with top facing down. Place  a  support  (88)  under  operating shaft  (78)  and  press  operating  fork (81 ) until spacer (82) does not move up or down. Lubricate operating shaft upper bearing (83). with engine oil and seat bearing in governor housing (3). Install  screw  and  washer  assembly (76), and washer (77) to secure bearing. Lubricate lower bearing (79) with engine oil and start bearing into governor housing (3) on operating shaft  (78). Place a 7/16-inch inside diameter sleeve on inner race of lower bearing (79).  Using  arbor  press,  install bearing on operating shaft (78) until bearing seats on shoulder in governor  housing  (3). Apply a thin coat of sealant to edge of expansion  plug  (75). Using  a  ballpeen  hammer,  tap expansion  plug  (75),  convex  side  up, into  governor  housing  (3). If removed, lubricate outside of two control link operating lever bearings (74) with engine oil and lubricate inside bearings with  grease.  Using  bearing  installer  (48), press one bearing into control link operating lever (72) until flush with top lever.   Reverse   operating   lever   (72)   and install second bearing (74) in same manner. Change 1