TM9-2815-202-34 f.  Installation (1) (2) (3) (4) (5) (6) (7) (8) (9) (10) (11) (12) (13) Secure pump and motor assembly (2) to bracket (25) with four bolts (34), four flat washers (37), four Iockwashers (36), and four nuts (35). Torque bolts to 7-9 Ib-ft (1 0-12 N-m). Install wiring harness lead (5) to terminal on pump and secure with nut (3) and Iockwasher (4). Connect  wiring  harness  connector  (1)  to  terminal  on  pump  and  motor  assembly  (2). For model 7083-7399 only, route hose (8) to front of engine. If removed, install clamp (22) onto hose (8) and secure hose to upper front cover with bolt (19), Iockwasher (20), flat washer (21 ), and clamp. Torque bolt to 71-75 Ib-ft (96-102 N-m). NOTE When  positioning  wiring  harness  (30)  on  engine,  route  harness  to  prevent  cuts, chaffing,  burns,  or  interference  with  components, Install bracket (25) assembly onto governor. Secure with two bolts (31 ), two Iockwashers (32), and four flat washers (33). If removed, install clamp (22) onto hose (8). Install two bolts (23) and two Iockwashers (24), securing bracket (25) and clamp to support (26). Torque bolts (23) to 35-39 Ib-ft (47-53 N-m). Torque bolts (31 ) to 7-9 Ib-ft (1 0-12 N-m). Install bolt (27), retainer (28), and clamp (29) securing wiring harness (30) to blower. Torque bolt to 30-35 Ib-ft (41-47 N-m). Connect tube (6) to elbow (7) on pump. For model 7083-7398 only, connect hose (8) to elbow (10) on fuel strainer, Connect tube (17) to elbow (18) on solenoid valve (38). Connect hose (8) to elbow (9) on pump and motor assembly (2). Install wiring harness connector (11 ) onto ignition coil (12). Install two wiring harness leads (15) to stud (16). Secure with Iockwasher (14) and nut (13). 6-18