| Tweet |
Custom Search
|
|
|
||
 TM 9-2815-220-24
FUEL/WATER SEPARATOR OPERATION TESTS
THIS WORK PACKAGE COVERS:
Before Tests, Tests, and After Tests
INITIAL SETUP:
Tools:
Mandatory Replacement Parts:
General mechanic's tool kit (item 121, WP 0176)
Filter element (1) (item 195, WP 0175)
Multimeter (item 75, WP 0176)
Filter element (2) (item 196, WP 0175)
Pipe plugs, 1/8-27 (2) (item 83, WP 0176)
Lock washer (4) (item 93, WP 0175)
24-volt dc power source (tool crib)
Lock washer (8) (item 92, WP 0175)
O-ring (item 197, WP 0175)
Suitable metal containers (1.0 gal (3.8 L)
minimum capacity) (2) (tool crib)
Personnel Required:
Fabricated Items:
Track Vehicle Repairer (1) 63H10
Fuel/water separator jumper wire (item 9,
Equipment Conditions:
Engine removed from vehicle and placed on a
Fuel/water separator test harness (item 8,
flat stationary surface
Expendable and Durable Items:
Diesel fuel, as needed (item 12, WP 0173)
Wiping rags (item 26, WP 0173)
NOTE
To verify that the fuel/water separator is functioning properly, all
tests in this work package must be performed and in the sequence
listed. All tests must be performed with fuel/water separator in an
upright and level position.
BEFORE TESTS
1. Dismount fuel/water separator (1) from bracket (2).
a. Remove four screws (3), with lock washers (4) and flat washers (5) securing fuel/water
separator (1) to bracket (2). Discard lock washers (4).
b. Remove clamp (6) from sensor probe wires (7).
c. Temporarily hang fuel/water separator from bracket with a bungee cord or other suitable
method.
2
1
7
6
5
4
3
WP 0042 00-1
|
||
|
||
