| Tweet |
Custom Search
|
|
|
||
 TM 9-2815-220-24
THIS WORK PACKAGE COVERS:
Removal, Installation
INITIAL SETUP:
Tools:
Mandatory Replacement Parts (Continued):
Fan rotor gauge (item 43, WP 0176)
Lock washer (12) (item 94, WP 0175)
General mechanic's tool kit (item 121, WP 0176)
Seal (2) (item 191, WP 0175)
Puller, Mechanical (2) (item 90, WP 0176)
Self-locking nut (2) (item 113, WP 0175)
Torque wrench, 0-600 foot-pounds (item 128,
Personnel Required:
Track Vehicle Repairer (2) 63H10
Mandatory Replacement Parts:
Equipment Conditions:
Cotter pin (2) (item 53, WP 0175)
Engine removed from vehicle and placed on a
Gasket (2) (item 257, WP 0175)
flat stationary surface
REMOVAL
NOTE
Removal of front and rear cooling fans and vanes are identical. Three
different length screws secure the cooling fan vane housings to the
cooling fan housings. Mark each screw during removal and note the
location to aid in proper placement during installation.
1. Remove front and rear vane housings (1).
a. Remove eight screws (2) with lock washers (3). Discard lock washers.
b. Remove two vanes housings (1) from engine.
2
3
1
1
WP 0054 00-1
|
||
|
||
