| Tweet |
Custom Search
|
|
|
||
 TM 9-2815-220-24
WIRING HARNESS AND CABLE REPAIR
0056 00
REPLACEMENT OF CONNECTORS (Continued)
Disassembly of Typical Female-Type Plug with Ridged Locking Nut
1. Heat boot (A) on shell assembly (B) and roll back on cable (C).
2. Unscrew nut (D) from shell assembly (B) and slide back on cable (C).
3. Drive socket contacts (E) out through rear of shell (F) with socket extractors.
4. Using soldering gun (item 108, WP 0176), unsolder or cut leads from socket contacts (E).
Assembly of Typical Female-Type Plug with Ridged Locking Nut
1. Strip cable (C) insulation equal to depth of wells in socket contacts (E).
2. Slide nut (D) onto cable (C).
3. Insert cable (C) leads into wells of socket contacts (E) and solder (using item 38, WP 0173) or
crimp.
4. Push socket contacts (E) into shell (F) from rear until seated.
5. Screw nut (D) onto shell assembly (B).
6. Apply a thin even layer of adhesive (item 1, WP 0173) to shell assembly (B) and roll boot (A)
onto shell assembly (B).
D
B
A
C
E
E
F
WP 0056 00-18
|
||
|
||
