| Tweet |
Custom Search
|
|
|
||
 TM 9-2815-220-24
ROCKER ARM ASSEMBLY AND COVER REPLACEMENT
THIS WORK PACKAGE COVERS:
Removal, Cleaning, Inspection, and Installation
INITIAL SETUP:
Tools and Special Tools:
Personnel Requirements:
General mechanic's tool kit (item 121, WP 0176)
Track Vehicle Repairer (2) 63H10
Torque wrench, 0-300 inch pounds (item 124,
Equipment Conditions:
Engine on flat stationary surface
Torque wrench, 200-1000 inch pounds (item 125,
Fuel/water separator removed (WP 0084)
Fuel injector tubes removed (WP 0113)
Torque wrench, 0-175 foot-pounds (item 127,
Cylinder oil drain back tubes removed
Mandatory Replacement Parts:
Engine oil cooler frames removed (0090)
Gasket (2) (item 291, WP 0175)
Fuel nozzle and holder removed (WP 0114)
Gasket (2) (item 350, WP 0175)
Seal washer (4) (item 194, WP 0175)
Expendable and Durable Items:
Lubriplate (item 23, WP 0173)
Sealant (item 33, WP 0173)
REMOVAL
NOTE
The engine has twelve rocker arm assemblies and covers. The
following procedures apply to one or all covers. If covers only need to
be removed from one bank, major assemblies can be removed from
just one bank.
Fuel/water separator need not be removed if rocker cover for cylinder
1L is not going to be removed.
WP 0104 00-1
|
||
|
||
