| Tweet |
Custom Search
|
|
|
||
 TM 9-2815-220-24
THROTTLE CONTROL SOLENOID ASSEMBLY AND ASSOCIATED PARTS
REPLACE/REPAIR (2DR)
0123 00
INSPECTION
CLEANING
1. See Work Package 0028 for General Cleaning Procedures.
INSPECTION
All parts must be inspected with care. Replace parts if damage or wear exceeds allowable
limits.
1. See Work Package 0028 for General Inspection Procedures.
44
2. Measure inside diameter (A) of solenoid
control housing (44), using inside
micrometer (item 16, WP 0176).
a. Replace solenoid control housing if
measurement is not between 0.8120 inch
(20.62 mm) and 0.8130 inch (20.65 mm).
A
3. Measure outside diameter of straight shaft (16) at points (B, C, and D), using outside
micrometer (item 17, WP 0176).
a. Replace shaft if measurement is not within limits in the following table.
Location
Sizes and Fits of New Parts inches (mm)
Wear Limits
B (Bearing areas)
0.6249 (15.87)
0.6252 (15.88)
0.6246 (15.86)
C (main shaft)
0.6245 (15.86)
0.6252 (15.88)
0.6240 (15.85)
D (Fuel shutoff lever)
0.6232 (15.83)
0.6252 (15.88)
0.6217 (15.79)
16
B
B
B
D
C
C
WP 0123 00-7
|
||
|
||
