| Tweet |
Custom Search
|
|
|
||
 TM 9-2815-220-24
THROTTLE/GOVERNOR CONTROL ROD (RIGID) ASSEMBLY REPAIR
THIS WORK PACKAGE COVERS:
Inspection and Repair
INITIAL SETUP:
Tools:
Personnel Required:
Dial indicator (item 65, WP 0176)
Track Vehicle Repairer (1) 63H10
Drill bit, 1/8-inch (item 10, WP 0176)
Equipment Conditions:
General mechanic's tool kit (item 121, WP 0176)
Engine removed from vehicle and placed on a
flat stationary surface
Portable electric drill (item 34, WP 0176)
Throttle linkage and associated parts removed
INSPECTION
All parts must be inspected with care. Replace parts if damage or wear exceeds allowable
limits.
1. See Work Package 0028 for General Inspection Procedures.
2. Measure the clearance (A) between ball and socket (endplay) of two rod end/bearings (1) at
each end of governor control rod (2), using dial indicator (item 65, WP 0176). Replace rod
end/bearing if not within the following limits.
Location
Sizes and Fits of New Parts inches (mm)
Wear Limits
A (Bearing endplay)
0.0005 (0.0127)
0.0015 (0.0381)
0.0020 (0.0508)
1
2
A
2
WP 0126 00-1
|
||
|
||
