| Tweet |
Custom Search
|
|
|
||
 TM 9-2815-220-24
CYLINDER ASSEMBLY REPLACEMENT
0133 00
REMOVAL (Continued)
CAUTION
Before removing each cylinder assembly, the crankshaft must be turned to
position the piston of the cylinder being removed to top center. Make certain
each piston is properly positioned before attempting cylinder removal.
Damage to piston may occur.
NOTE
Model 2DR crankshaft may be
turned from the flywheel or from
the power takeoff coupling.
Flywheels on models 2DR are
different and require different
turning tools than those for engine
models 2CA and 2DA.
4. Install proper turning tool for your engine
Model 2DR Front Turning Tool:
model as shown.
(item 3, WP 0177)
Position fabricated engine turning tool on
power takeoff coupling and secure with
four 7/16-20 UNF x 1-1/2 inch machine
bolts. Use a 1-1/4 inch socket and a 3/4-
inch breaker bar to turn engine crankshaft.
Models 2CA and 2DA
Flywheel Turning Tool:
(item 136, WP 0176)
Model 2DR Flywheel Turning Tool:
Transmission spur gear should already
(item 4, WP 0177)
be in place on flywheel; if not, place in
Position fabricated engine turning tool on
position and secure with two bolts.
flywheel and secure with four 7/16-20
Use splined wrench (turning tool) to
UNF x 1-1/2 inch machine bolts. Use a
turn engine crankshaft.
1-1/4 inch socket and a 3/4-inch breaker
bar to turn engine crankshaft.
WP 0133 00-4
|
||
|
||
