| Tweet |
Custom Search
|
|
|
||
 TM 9-2815-226-34-2
Section XVIII. REAR COVER REPAIR
3-46. DISASSEMBLE, INSPECT, AND REPAIR REAR COVER
a. Place cover on support blocks with rear face down.
b. Carefully remove oil seal and discard seal.
WARNING
COMPRESSED AIR USED FOR CLEANING PURPOSES WILL NOT EXCEED 30
PSI (207 KPA).
USE ONLY WITH EFFECTIVE CHIP GUARDING AND
PERSONAL PROTECTIVE EQUIPMENT (GOGGLES, SHIELD, GLOVES, ETC.).
P-D-680 SOLVENT IS POTENTIALLY DANGEROUS. AVOID PROLONGED OR
REPEATED CONTACT WITH SKIN. KEEP AWAY FROM FLAME OR EXCESSIVE
HEAT.
c. Clean cover with solvent and dry thoroughly with compressed air.
d. Check cover for cracks, nicks, burrs, and distortions. Discard if cracked or distorted.
e. Remove nicks and burrs with emery cloth.
3-230
|
||
|
||
