| Tweet |
Custom Search
|
|
|
||
 TM 9-2815-226-34-2
CAUTION
DO NOT OVERTORQUE CLAMP NUTS. THIS CAUSES CLAMP DISTORTION.
s. Install new bolts and nuts securing clamp halves (14) in position and torque nuts to 31 - 36 in. lbs (3.6 - 4. 1 Nm).
Ensure that clamps are seated correctly and equal gap exists at clamp closing points.
t. Measure clearance between V-band clamp and turbine housing at oil port openings in clamp. There must be no
less than 0.035 in. (0.889 mm) clearance. If less than 0.035 in. (0.889 mm), change clamp.
u. Check radial clearance at turbine wheel and compressor wheel.
Change 1 3-387
|
||
|
||
