| Tweet |
Custom Search
|
|
|
||
 TM 9-2815-226-34-2
aa.
Install oil pan.
(1)
Rotate engine to upside down position.
(2)
Install two guide studs in oil pan flange of block, one on each side.
(3)
Apply gasket sealant to block flange and place gasket on flange.
(4)
Check pan screen to ensure proper assembly and security of screws.
(5)
Position oil pan over guide studs and start 28 capscrews, flat washers, and lockwashers by hand.
(6)
Install four capscrews, flat washers, and lockwashers through rear flange at both sides of pan.
These screws pull pan tight and square against flywheel housing.
(7)
Lock pan in position by tightening two center capscrews on each side of block.
3-450
|
||
|
||
