TM 9--2815--247--34 0037 00--10 FUEL INJECTOR TUBES, BRACKETS, AND ASSOCIATED PARTS -- CONTINUED 0037 00 Installation -- Continued 7.   Install four lower fairlead halves (4) between tube assemblies and four double--angle brackets (5, 6, 7, and 8) with cut--off corners adjacent to manifolds. CAUTION Where bending tubes is required, be careful not to nick tubing. The bending tools are designed to allow bending without nicks. 8.   Using two bending tools (72), align tubes to fit within 1/8 inch (3.175 mm) in any direction with fairlead halves, which should be aligned with bracket bolt holes. 9.   Apply a small amount of lubricant (item 12, WP 0100 00) to threads of 16 bolts (1). 10. Install four remaining fairlead halves (4), four retaining straps (3), 16 bolts (1), and 16 new self--locking nuts (2), (DETAIL A) onto four double--angle brackets (5, 6, 7, and 8). 11. Tighten 16 bolts (1) to 160--180 lb--in (18--20 NSm). Figure 36 FLYWHEEL END DAMPER END RIGHT BANK LEFT BANK A A A A A 1 2 3 4 4 72 72 8 7 6 5