TM 9--2815--247--34 0037 00--12 FUEL INJECTOR TUBES, BRACKETS, AND ASSOCIATED PARTS -- CONTINUED 0037 00 Installation -- Continued 17. Install angle bracket (17), using two new self--locking nuts (65). 18. Tighten two self--locking nuts (65) to 150--175 lb--in (17--20 NSm). 19. Install lower fairlead half (16) between tube assembly and angle bracket (17). CAUTION Where bending tubes is required, be careful not to nick tubing. The bending tools are designed to allow bending without nicks. 20. Using two bending tools (72), align tube to fit within 1/8 inch (3.175 mm) in any direction with fairlead half, which should be aligned with bracket bolt holes. 21. Apply a small amount of lubricant (item 12, WP 0100 00) to threads of two new self--locking bolts (14). 22. Install remaining fairlead half (16), retaining strap (15), and two self--locking bolts (14) (DETAIL C) onto angle bracket (17). 23. Tighten two self--locking bolts (14) to 160--180 lb--in (18--20 NSm). Figure 36 RIGHT BANK LEFT BANK FLYWHEEL END DAMPER END C C 14 15 16 16 17 72 72 65