TM 9--2815--247--34 0088 00--1 AUTOMATIC FUEL INJECTION ADVANCE CONTROL ASSEMBLY AND ASSOCIATED PARTS REPAIR 0088 00 THIS WORK PACKAGE COVERS: Removal, Disassembly, Inspection, Assembly, Test, Adjustment, Installation INITIAL SETUP: Tools and Special Tools General mechanic’s tool kit (item 19, WP 0103 00) Outside micrometer caliper set (item 9, WP 0103 00) Inside micrometer caliper set (item 10, WP 0103 00) Telescoping gauge set (item 16, WP 0103 00) Torque wrench (item 49, WP 0103 00) Fuel injection advance test stand (item 15, WP 0103 00) Spring tester (item 47, WP 0103 00) Snapring pliers (item 44, WP 0103 00) Crowfoot attachment (item 93, WP 0103 00) Puller kit mechanical (item 101, WP 0103 00) Screwdriver (item 100, WP 0103 00) Materials/Parts Cotter pins (8) (item 91, WP 0102 00) Retaining ring (item 116, WP 0102 00) Nonelectrical wire (item 22, WP 0100 00) Spring pins (4) (item 159, WP 0102 00) Materials/Parts -- Continued Retaining ring (item 110, WP 0102 00) Cotter pins (2) (item 90, WP 0102 00) Retaining ring (item 114, WP 0102 00) Seals (8) (item 127, WP 0102 00) Lubricant (item 12, WP 0100 00) Safety goggles (item 28, WP 0100 00) Equipment Conditions Engine on maintenance stand (WP 0056 00) Housing assembly, accessory drive and associated parts removed (WP 0085 00) Removal 1.   Remove and discard eight cotter pins (1). 2.   Remove two slotted nuts (2) and two flat washers (3) securing cap (4). 3.   Remove cap (4) from accessory housing assembly (5). 1 1 1 1 2 3 4 5 Figure 30