TM 9-2815-250-24&P
3-6.
CRANKCASE REPAIR (continued).
4.
Remove nut (21), two washers (3), and screw (4) from upper crankcase (23) and lower crankcase (22) on
injection-pump side of engine.
5.
Remove three nuts (5), washers (20), and screws (19) from upper crankcase (23) and lower crankcase (22) on
injection-pump side of engine.
6.
Remove three nuts (14), six washers (9), and three screws (8) from upper crankcase (23) and lower crankcase
(22) on starter side of engine.
7.
Remove two nuts (10), four washers (11), two screws (13), and air duct bracket (12) from upper crankcase (23)
and lower crankcase (22).
3-21
|
|
