TM9-2815=202-34 4-30.   CYLINDER   BLOCK   END   PLATES   REPLACEMENT Thistaskcovers: a.  Removal b. Cleaning/Inspection c.  Repair d.  Installation .  . INITIAL   SETUP MODELS EXPENDABLE/DURABLE    SUPPLIES n All TOOLS  AND  SPECIAL  TOOLS Gasket nonhardening cement (App C, Item 39) Cleaning  solvent  (App C, Item 10) EQUIPMENT  CONDITION General  mechanics  tool  kit  (App B, Item 96) Torque wrench  (App B, Item 101) MANDATORY  REPLACEMENT  PARTS 2 Lockwashers  (App F, Item 95) 13  Lockwashers  (App F,ltem   93) 1 Gasket (App F,ltem  22) 1 Gasket (App F,ltem  43) 1 Gasket (App F, Item 67) Para   Description 4-5 Fuel strainer bracket removed (7083-7395  and  7083-7398) 4-19 Blower drive-support removed 4-25  Idler  gear  removed 4-29  Camshaft  and  camshaft  end  bearings removed a.   Removal (1) Front End Plate NOTE n Models 7083-7391, 7083-7396, and 7083-7399 require removal of two bolts (1) and two Iockwashers  (2). (a) Remove bolt (1) and  lockwasher  (2) from end plate (3). Discard  Iockwasher. NOTE n Models 7083-7391, 7083-7396, and 7083-7399 require five bolts (4) and five Iockwashers  (5). (b) Remove four bolts (4) and four  Iockwashers  (5) from end plate. Discard  Iockwashers. (c)  Remove  end  plate  (3)  and  gaskets  (6  and  7)  from  cylinder  block  (8).  Discard  gaskets. (d) If required, remove screw insert (9) by pressing from end plate. Support end plate on a flat  surface  when  removing  insert  to  prevent  warping  or  bending. f 1 . 4-116 Change 1