SECTION III. MAINTENANCE PROCEDURES - TM-9-6115-666-13-P0133

Custom Search

Back
Figure 5-2. Power Plant fails to parallel

Up
TM-9-6115-666-13-P AN/MJQ-1612 60kW 50/60 Hz Power Plant Diesel Engine Driven 5 Ton Trailer Mounted Manual

Next
Figure 5-3. Generator Replacement

ARMY TM 9-6115-666-13&P

AIR FORCE TO 35C2-3-505-1

SECTION III. MAINTENANCE PROCEDURES

5.5. GENERAL.

Refer to TM 9-6115-645-24 for generator set maintenance, and to TM 9-2815-256-24 for engine maintenance.

Refer to TM 9-2330-376-14&P for trailer maintenance. Direct Support maintenance procedures are provided in

5.6. REPLACE GENERATOR SET.

This task covers:

a. Removal

b. Installation

INITIAL SETUP :

Tools

Equipment Conditions

Tool Kit, General Mechanic's

Reference

Both generator sets shut down, paragraph 2.7.1

Lifting device with a minimum 6000 lb. capacity

Trailer supports devices are lowered.

Personnel Required

Four

REMOVAL

WARNING

When lifting the generator set, use lifting equipment with a minimum lifting capacity of 6000

lb. Do not stand under the generator set while it is being lifted. Do not permit generator set

to swing. Failure to observe this warning can result in severe personal injury or death.

1. When removing the generator set from the power plant trailer, disconnect cable W1 or W2 (1, figure

5-3) depending on the generator to be removed. W1 is connected to generator set 1 and W2 is

connected to generator set 2. Refer to FO-1 and table 5-6 and table 5-7 for assistance in

disconnecting cables.

2. Disconnect paralleling cable (2) from generator set paralleling connector.

3. Disconnect auxiliary fuel line (3) connected to generator set (4).

4. Disconnect ground cable from generator terminal (5).

5-6